- Insert the free wheel on the flywheel as shown in the pic-
ture.
- Hence refit the flywheel with the intermediate gear and the
free wheel.
- Using the special flywheel retaining tool, tighten the lock-
nut to the prescribed torque.
- Refit the retaining plate.
Specific tooling
020627Y flywheel stop key
Locking torques (N*m)
Flywheel lock-nut 94 ÷ 102
R
EFITTING THE STARTER MOTOR
G
S
Version 250
- Install a new O-Ring on the starter motor and lubricate it.
- Install the starter motor on the engine crankcase and tig-
hten the 2 screws at the prescribed torque.
- Replace the remaining parts as described in the Timing head
cylinder, lubrication, flywheel and transmission chapters.
Locking torques (N*m)
TStarter motor screws 11 ÷ 13
Version 125
- Install a new O-Ring on the starter motor and lubricate it.
- Install the starter motor on the engine crankcase and tig-
hten the 2 screws at the prescribed torque.
- Replace the remaining parts as described in the Timing head
cylinder, lubrication, flywheel and transmission chapters.
Locking torques (N*m)
Starter motor screws 11 ÷ 13
102
O O