Download  Print this page

Derbi GP1 125-250 c.c. Workshop Manual Page 76

Gp1 125-250 c.c..
Hide thumbs

Advertisement

Table of Contents
- Make sure that the clutch is perfectly inserted into the
adapter ring before proceeding to release and tighten the
clutch nut.
- Using the specific wrench 46x55 component n° 9, remove
the clutch fixing nut.
- Separate the components of the driven pulley (clutch, fan
and spring with plastic rest).
CAUTION
THE TOLL MUST BE TIGHTLY FIXED IN THE VICE AND THE
CENTRAL SCREW MUST BE MOVED IN ABUTMENT WITH
THE TOOL. AN EXCESSIVE TORQUE MAY DEFORM THE SPE-
CIFIC TOOL.
Specific tooling
020444Y009 wrench 46 x 55
020444Y008 adapter ring
Version 250
Prepare the specific driven pulley spring compressor tool
with the medium length pins in position «C" tightened on the
inside of the tool.
- Introduce the adapter ring n° 11 with the chamfering facing
the inside of the tool.
- Install the driven pulley assembly onto the tool inserting
the 3 pins into the ventilation holes obtained on the mass
holding support.
- Make sure that the clutch is perfectly inserted into the
adapter ring before proceeding to release and tighten the
clutch nut.
- Using the specific wrench 46x55 component n° 9, remove
the clutch fixing nut.
- Separate the components of the driven pulley (clutch and
spring with plastic rest).
CAUTION
THE TOLL MUST BE TIGHTLY FIXED IN THE VICE AND THE
CENTRAL SCREW MUST BE MOVED IN ABUTMENT WITH
THE TOOL. AN EXCESSIVE TORQUE MAY DEFORM THE SPE-
CIFIC TOOL.
Utillaje específico
020444Y011 Adapter ring
020444Y009 wrench 46 x 55
020444Y Driven half pulley spring compressor tool
75

Advertisement

Table of Contents

This manual is also suitable for:

Gp1 125 c.c.Gp1 250 c.c.

Comments to this Manuals

Symbols: 0
Latest comments: