Table of Contents
Advertisement
C
C
-
ENTRE
ENTRE STAND
STAND
- Remove the two stand return springs.
- Unscrew the nut shown in the figure.
- Remove the pivot from the right-hand side.
- Remove the stand.
- After refitting the stand, tighten the nut with the prescribed
torque.
Locking torques (N*m)
Central stand bolt 25 ÷ 30
REMOVAL
- Release the springs.
- Loosen the nut.
- Extract the screw.
RE-ASSEMBLY
Insert the sealing rings on the side stand support tube; per-
form the above operations in the reverse order, then move
the sealing rings to their seats.
CAUTION
LUBRICATE THE FOLLOWING PARTS WITH GREASE TUTELA
Z2: SPRING PINS, BUSHES ON STAND FIXING BRACKETS.
Recommended products
Grease for steering wheel bearings and pin seats
Lithium soap and zinc oxide grease NLG12 for the osci-
llating arm
Locking torques (N*m)
Fastening screw 20 ÷ 25
183
Advertisement
Table of Contents
