Derbi GP1 125-250 c.c. Workshop Manual page 196

A A
SSEMBLING THE FRONT WHEEL SSEMBLING THE FRONT WHEEL
Reverse the "DISMANTLING" procedures. Take care
with the following points:
1. Lubricate:
- Front wheel axle.
- Bearing.
- Retaining rings.
Recommended lubricant:
Lithium soap based grease
2. Fit:
- Front wheel
3. Tighten:
- Front wheel axle.
- Axle nut (front wheel).
ATTENTION
BEFORE TIGHTENING THE WHEEL AXLE, PUSH THE FRONT
FORKS DOWN SEVERAL TIMES, HOLDING THE HANDLE-
BARS, TO CHECK THEIR OPERATION.
Axle nut:
70-80 N.m (7-8 kgf.m)
WARNING
ENSURE THAT THE SPEEDOMETER CABLE GUIDE IS CO-
RRECT.
4. Check:
Front brake functioning
Irregular functioning => Dismantle or check again.
- Brake lever play
195