Download  Print this page

Checking The Valve Clearance; Cooling System - Derbi GP1 125-250 c.c. Workshop Manual

Gp1 125-250 c.c..
Hide thumbs

Advertisement

Table of Contents
C
C
HECKING THE VALVE CLEARANCE
HECKING THE VALVE CLEARANCE
-To check the valve clearance, you have to make the point
references coincide
-Check that the clearance between the valve and register co-
rresponds to the values shown using a proper thickness gau-
ge. If the values of the valve clearances - intake and dischar-
ge, respectively are different than those given below, adjust
them by loosening the lock nut and using a screwdriver on
the register as shown in the figure.
Air intake:
0,10 mm (cold)
Discharge:
0,15 mm (cold)
C
C
OOLING SYSTEM
OOLING SYSTEM
T
-
OP
UP
The fluid level inspection should be carried out every 6,000
km when the motor is cold, following the methods indicated
below:
- Rest the vehicle on the central stand and on a flat ground.
Accessing the coolant level indicator
To check the level of coolant, remove the cap on top (remove
screws 1 and 2).
- Top up, if ffie fluid leveT is near to or below the MIN level
into the expansion tank. The fluid level should always be bet-
ween the MIN and MAX level.
- The cooling fluid consists of a mixture of 50 deminerali-
sed water and ethylene glycol and corrosion inhibitors based
anti-freeze solution.
ATENCIÓN
TO PREVENT THE COOLANT FROM LEAKING OUT OF THE
EXPANSION TANK DURING USE, BE SURE TO NEVER EX-
CEED THE MAX LEVEL WHEN REFILLING
59

Advertisement

Table of Contents

This manual is also suitable for:

Gp1 125 c.c.Gp1 250 c.c.

Comments to this Manuals

Symbols: 0
Latest comments:
  • LIAM May 27, 2017 06:12:
    HI HAVE JUST BOUGHT A DERBI 125 CC CROSS CITY, REALLY WOULD LIKE TO BUY A WORKSHOP MANUAL PLEASE CAN YOU HELP