Table of Contents
Advertisement
Perform this operation when the engine cold, as des-
cribed below:
1) Put the vehicle on its central stand on a flat surface.
2) Unscrew dipstick "A", dry it with a clean cloth and refit by
screwing it completely.
3) Remove the dipstick again and check that the oil level is
between the MAX and MIN marks on the dipstick; top up if
necessary.
The MAX level mark indicates an amount of about 1100 cc
of engine oil. The level will be lower if checked after using
the vehicle (i.e. when the engine is hot). To obtain a correct
indication of the oil level, wait for at least 10 minutes after
switching off the engine.
Characteristic
Engine oil (125)
-1100 cc
Engine oil (250)
-1200 cc
If the oil level is too low, top up by adding fresh oil without
exceeding the MAX level.
Approximately 400 cc of oil are needed to restore the level
between the MIN and MAX marks.
E
NGINE OIL FILTER
G
O
The oil cartridge must be replaced with every oil replace-
ment. For top-ups and replacements only use fresh oil of the
recommended type.
Check that the net filter O-rings and drainage cap are not
worn out and in good conditions. Lubricate O-rings and re-
place net filter and oil drainage cap; tighten at the prescri-
bed torque. Install the new cartridge filter after lubricating
the O-ring. Fill with fresh engine oil.
Recommended products
Engine oil 4T
Synthetic oil SAE 10W/40 of higher quality than API SJ
specifications
57
Advertisement
Table of Contents
