Table of Contents
Advertisement
Heat the flywheel cover using the heat gun
N.B.
IF THE JOB IS PERFORMED WITH THE STATOR MOUNTED,
HEAT FROM THE EXTERNAL SIDE OF THE COVER.
Specific tooling
020151Y Air heater
020150Y Support for air heater
Properly support the cover and using the modular punch,
install the two bearings all the way down at the same time.
N.B.
WORK IN AN UPRIGHT POSITION
Utillaje específico
020376Y Handle for punches
020441y 26 x 28 mm adaptor
020629y 8 mm guide
Let the flywheel cover guard cool down and then manually
mount the static part of the ceramic seal with the relative
rubber seal.
N.B.
PAY ATTENTION TO MOUNTING THE CERAMIC RING CO-
RRECTLY. THE CHAMFER ON THE INTERNAL DIAMETER
MUST BE TURNED AWAY FROM THE SIDE OF THE BEA-
RINGS.
Mount the moving part of the ceramic seal on the shaft with
the impeller. The rubber part must rest against the impeller.
214
Advertisement
Table of Contents
