I
I
NSPECTING THE FLYWHEEL COMPONENTS
NSPECTING THE FLYWHEEL COMPONENTS
- Check the integrity of the internal plastic parts of the
flywheel and the Pick-Up control plate.
R
R
EFITTING THE FLYWHEEL MAGNETO
EFITTING THE FLYWHEEL MAGNETO
- Install the flywheel being careful to the proper introduction
of the key.
- Tighten the flywheel nut at the prescribed torque.
- Check that the Pick-Up air gap ranges between 0.34 ÷
0.76 mm.
- The Pick-Up assembly requires no gap adjustment.
- Different values are caused by deformations of the Pick-Up
support.
N.B.
A VARIATION IN THE GAP DISTANCE CHANGES THE MINI-
MUM DELIVERY SPEED OF THE IGNITION SYSTEM.
Specific tooling
020565Y Compass flywheel stop spanner
Locking torques (N*m)
Flywheel nut 54 ÷ 60
- Remove the free wheel retaining plate shown in the pictu-
re.
- Remove the intermediate gear and the free wheel.
101