Download  Print this page

End Gear; Removing The Hub Cover; Removing The Wheel Axle - Derbi GP1 125-250 c.c. Workshop Manual

Gp1 125-250 c.c..
Hide thumbs

Advertisement

Table of Contents
- Replace the steel washer and the driven pulley nut.
- Tighten the nut at the prescribed torque using the lock
wrench and the dynamometric wrench tools.
- Replace the plastic cover.
Specific tooling
020423Y driven pulley stop key
Locking torques (N*m)
Cover screws 11-13 Driven pulley axis 54 ÷ 60
E
E
ND GEAR
ND GEAR
R
EMOVING THE HUB COVER
- Drain the rear hub by the oil drainage cap.
- Remove the 7 flanged screws shown in the figure.
- Remove the hub cover and the relevant gasket.
R
R
EMOVING THE WHEEL AXLE
EMOVING THE WHEEL AXLE
- Remove the wheel axle with gear.
- Remove the intermediate gear.
90

Advertisement

Table of Contents

This manual is also suitable for:

Gp1 125 c.c.Gp1 250 c.c.

Comments to this Manuals

Symbols: 0
Latest comments:
  • LIAM May 27, 2017 06:12:
    HI HAVE JUST BOUGHT A DERBI 125 CC CROSS CITY, REALLY WOULD LIKE TO BUY A WORKSHOP MANUAL PLEASE CAN YOU HELP