Engine Crankcase And Shaft; Cooling - Derbi GP1 125-250 c.c. Workshop Manual

E
NGINE CRANKCASE AND SHAFT
NAME
Engine crankcase inside head screws
(transmission side half shaft)
Engine crankcase coupling screws
Starter motor screws
Crankcase timing cover screws
C
OOLING
NAME
Water pump impeller cover
Water pump impeller drive joint screw
Thermostat cover screws
(°) Apply threadlocking LOCTITE médium, type 242.
(*) Tighten the two screws after tightening the rear wheel spindie nut with the prescribed torque.
(A)Tighten the nuts ¡n two phases, following a crosswise pattern.
(1) Lubrícate nuts with engine oil before fitting.
21
TORQUE IN Nm
4 ÷ 6
11 ÷ 13
11 ÷ 13
3,5 ÷ 4,5
TORQUE IN Nm
3 ÷ 4
3 ÷ 4
3 ÷ 4