Table of Contents
Advertisement
B
B
RAKING SYSTEM
RAKING SYSTEM
Level check
Proceed as follows:
- Rest the vehicle onto its centre-stand and align the han-
dlebars;
- Check the liquid level through the inspection hole «A».
A certain decrease in the liquid level is due to the wear of
the pads.
Top-up
Use the following procedure:
Loosen the two screws, remove the reservoir cap, remove
the gasket and top up only with the prescribed fluid without
exceeding the maximum level.
CAUTION
USE ONLY DOT 4 BRAKE FLUID.
CAUTION
KEEP THE BRAKE FLUID AWAY FROM THE SKIN, THE EYES
AND CLOTHING. IN CASE OF CONTACT, RINSE GENE-
ROUSLY WITH WATER.
CAUTION
THE BRAKE FLUID IS HIGHLY CORROSIVE. TAKE CARE NOT
TO SPILL IT ON THE PAINTWORK.
CAUTION
THE BRAKE FLUID IS HYGROSCOPIC, I.E. IT ABSORBS HUMI-
DITY FROM THE AIR. IF THE HUMIDITY CONTAINED IN THE
FLUID EXCEEDS A GIVEN CONCENTRATION, THE BRAKING
ACTION BECOMES INSUFFICIENT.
NEVER DRAW THE FLUID FROM OPEN OR PARTLY EMPTY
CONTAINERS.
UNDER NORMAL CLIMATIC CONDITIONS THE FLUID
SHOULD BE RENEWED EVERY 20,000 KM, OR IN ANY CASE
EVERY TWO YEARS.
N.B.
CHANGE THE BRAKE FLUID AND BLEED THE SYSTEM AS
DESCRIBED IN CHAPTER BRAKING SYSTEM
Recommendede products
Synthetic fluid SAE J 1703 NHTSA 116 DOT 4, ISO 4925
60
Advertisement
Table of Contents
