A
A
UTOMATIC TRANSMISSION
UTOMATIC TRANSMISSION
T
RANSMISSION COVER
To remove the transmission cover it is necessary to remove
the plastic cover first, using a screwdriver on the special gui-
des. Using the clutch bell lock wrench shown in the figure,
remove the driven pulley axle locking nut and washer.
Specific tooling
020423Y driven pulley stop key
- Remove the cap/bar of the engine oil filling hole.
- Remove the 10 screws.
- Remove the transmission cover. If this operation is perfor-
med directly on the vehicle, it is necessary to remove the
transmission compartment cooling air sleeve first.
A
A
IR DUCT
IR DUCT
- Remove the transmission cooling air inlet, shown in the pic-
ture.
Version 125
- Remove the 4 screws and the case.
71