Updating The Firmware; Installing The Gdi Printer/Twain Driver Using Plug And Play - Konica Minolta Di1610 Service Manual

5-2.

Updating the Firmware

NOTES
• The TWAIN driver must already be installed on the host computer to be used for updating
the firmware.
• If the GDI printer or TWAIN driver is not installed, follow the procedure described below
to install the driver.
• If the driver is already installed, skip to "Procedure for Updating the Firmware" and
update the firmware.
(1)

Installing the GDI Printer/TWAIN Driver Using Plug and Play

<For Windows XP>
1. Start up the host computer, and then insert the CD-ROM into the CD-ROM drive.
2. Turn on the printer.
3. Use a USB cable to connect the printer to the host computer.
4. In the "Found New Hardware Wizard" dialog box, select "Install from a list or specific
location [Advanced]", and then click the [Next] button.
5. Below "Search for the best driver in these locations.", select "Include this location in the
search", and then click the [Browse] button.
6. Specify "\Corresponding_language\WinXP" on the CD-ROM, and then click the [OK]
button.
7. Click the [Next] button, and then click the [Finish] button.
8. When the "Found New Hardware Wizard" dialog box appears again, repeat steps 4
through 7 to install all drivers.
<For Windows 2000>
1. Start up the host computer, and then insert the CD-ROM into the CD-ROM drive.
2. Turn on the printer.
3. Use a USB cable to connect the printer to the host computer.
4. In the "Install Hardware Device Drivers" dialog box, select "Search for a suitable driver
for my device (recommended)", and then click the [Next] button.
5. In the "Locate Driver Files" dialog box, select "Specify a location", and then click the
[Next] button.
6. Click the [Browse...] button, specify "\Corresponding_language\Win2K" on the CD-
ROM, and then click the [OK] button.
7. Click the [OK] button, and then continue following the instructions in the dialog boxes
that appear until the "Completing the Found New Hardware Wizard" dialog box
appears.
8. Click the [Finish] button.
9. When the "Found New Hardware Wizard" dialog box appears again, repeat steps 4
through 8 to install all drivers.
D-41