Individual Identification Codes
(ID)
Purpose
With this function you can assign
identifiers to values for
documentation and printouts.
You can use this extra function in
combination with a program from
Application 1 (e.g., counting,
weighing in percent), one from
Application 2 (checkweighing,
time-controlled functions) and one
from Application 3 (totalizing,
formulation, statistics) as well as with
the other extra functions.
100
Available Features
– Store up to 4 IDs; these can
be stored, changed or deleted
individually.
– Each ID consists of a name and
a value; both can be defined by
the user.
– ID designations are configured
in the Setup: Input menu.
– Each ID designation can have
up to 20 characters; when you
enter the value later, however, no
more than 15 characters of the
designation are displayed.
– The ID values are entered while
the application program
is active; press the
soft key to
ID
toggle to the ID input mode.
– Each ID value can have up to
20 characters.
– Access 1 of the 4 IDs directly
using the numeric keys. The other
three can only be accessed by
pressing the
soft key to toggle
ID
to the identifier input mode.
– You can assign this function to
the fourth or fifth soft key (from the
right), i.e. F4 or F5.
– You can configure when
the ID is included on the printout
(see "Preparation," this page).
– You can configure the position
of IDs on the individual or total
printout.
– The designation is printed flush
left; the value flush right. If the
name and value together are too
long for one line, the data is
printed on two lines.
– Optional configuration in the
Setup menu to delete a single
character when entering an
identifier by pressing c. Basic
settings: Keypad: CF function
for input: Delete last character
– Press the
soft key to
Delete
delete an ID
Factory Settings for ID Designations
ID1:
ID1
ID2:
ID2
ID3:
ID3
ID4:
ID4
Factory Settings for ID Values
No values set
Factory Settings for Other
Parameters
Printout:
Each time the
print key is pressed
Soft Key Functions
Toggle to "Identification
ID
codes" menu
Delete input of selected ID
Delete