Individual Identification Codes (Id) - Sartorius FC Operating Instructions Manual

Individual Identification Codes (ID)

Purpose
With this function, you can assign
IDs to values for documentation and
printouts.
You can use this function in
combination with any program from
Application 1 (such as counting,
weighing in percent), one from
Application 2 (checkweighing, time-
controlled functions) and one from
Application 3 (totalizing, formulation,
statistics) as well as with the other
extra functions.
86
Features
– Store up to 4 IDs; these can be stored,
changed or deleted individually.
– Each ID consists of a name and a value;
both can be defined by the user.
– ID designations are configured as
follows: Setup: Printout: Identification
codes
– Each ID code can have up to
20 characters; when you enter the
value later, however, no more than
15 characters of this ID are displayed.
– The ID values are entered while the
application program is active; press the
ID
soft key to toggle to the ID input
mode.
– Each ID value can have up to
20 characters.
– Access 1 of the 4 IDs directly using the
numeric keys. The other three can only
be accessed by pressing the
to toggle to the ID input mode.
– You can assign this function to the
fourth or fifth soft key (from the right);
i.e., F4 or F5.
– You can configure when the ID will
be included on the printout (see
"Preparation" on the next page).
– You can configure the position of IDs
on the individual or total printout.
– The ID code is printed flush left; the
value flush right. If the name and value
together are too long for one line, the
data is printed on two lines.
– Optional configuration in the Setup
menu to delete a single character when
entering an identification code by
pressing c. Setup: Device parameters:
Keys: CF function for input: Delete last
character
Delete
– Press the soft key to delete
an ID
Factory Settings of the ID Names
ID1
ID1:
ID2
ID2:
ID3
ID3:
ID4
ID4:
Factory Settings for ID Codes
No values set
Factory Settings
Printout:
Each time the print key
is pressed
Soft Key Functions
ID
Delete
Printout of ID Codes
Up to 4 (stored) identification codes are
printed out.
ID1
ID2 Daimler/Chrysler
ID
soft key ID3
ID4
ID1: Identification 1 (ID 1)
ID2: Identification 2 (ID 2)
ID3: Identification 3 (ID 3)
ID4: Identification 4 (ID 4)
Toggle to "Identification
codes" menu
Delete input of selected ID
Lot no. 1234
Screws M4x6
Jack Smith