Lldp Snmp-Trap - TP-Link JetStream TL-SL5428E Cli Reference Manual

Syntax
lldp transmit
no lldp transmit
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable Fast Ethernet port 1 to transmit LLDPDU:
TL-SL5428E(config)# interface fastEthernet 1/0/1
TL-SL5428E(config-if)#lldp transmit

lldp snmp-trap

Description
The lldp snmp-trap command is used to enable the port's SNMP notification. If
enabled, the port will notify the trap event to network management system. To
disable the ports' SNMP notification, please use no lldp snmp-trap command.
Syntax
lldp snmp-trap
no lldp snmp-trap
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the SNMP notification for Fast Ethernet port 1:
TL-SL5428E(config)#interface fastEthernet 1/0/1
TL-SL5428E(config-if)#lldp snmp-trap
TL-SL5428E JetStream L2 Managed Switch CLI Guide
291