Chapter 31 Ethernet Oam Commands; Ethernet-Oam; Ethernet-Oam Mode - TP-Link JetStream TL-SL5428E Cli Reference Manual
24-port 10/100mbps + 4-port gigabit jetstream l2 managed switch
Hide thumbs
Also See for JetStream TL-SL5428E:
- Reference manual (341 pages) ,
- User manual (307 pages) ,
- Cli reference manual (224 pages)
Table of Contents
Advertisement
Chapter 31 Ethernet OAM Commands
Ethernet OAM (standing for Operation, Administration, and Maintenance) is Layer 2 protocol that
is used for monitoring and troubleshooting Ethernet networks. It can report the network status to
network administrators through the OAMPDUs exchanged between two OAM entities. The
operation of OAM on an Ethernet interface does not adversely affect data traffic as OAM is a slow
protocol with very limited bandwidth potential.
ethernet-oam
Description
The ethernet-oam command is used to enable the Ethernet OAM function for
the desired port. To disable the Ethernet OAM function, please use no
ethernet-oam command.
Syntax
ethernet-oam
no ethernet-oam
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the Ethernet OAM function for Fast Ethernet port 2:
TL-SL5428E(config)# interface fastEthernet 1/0/2
TL-SL5428E(config-if)#ethernet-oam
ethernet-oam mode
Description
The ethernet-oam mode command is used to configure the OAM mode for the
desired port. To return to the default configurations, please use no
ethernet-oam mode command. The default mode is active.
TL-SL5428E
JetStream L2 Managed Switch CLI Guide
217
Advertisement
Table of Contents
Need help?
Do you have a question about the JetStream TL-SL5428E and is the answer not in the manual?