Pppoe Circuit-Id Type - TP-Link JetStream TL-SL5428E Cli Reference Manual
24-port 10/100mbps + 4-port gigabit jetstream l2 managed switch
Hide thumbs
Also See for JetStream TL-SL5428E:
- Reference manual (341 pages) ,
- User manual (307 pages) ,
- Cli reference manual (245 pages)
Table of Contents
Advertisement
Syntax
pppoe circuit-id
no pppoe circuit-id
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Enable the PPPoE Circuit-ID Insertion function for the Fast Ethernet port 1/0/1:
TL-SL5428E (config)# interface fastEthernet 1/0/1
TL-SL5428E (config-if)# pppoe circuit-id
pppoe circuit-id type
Description
The pppoe circuit-id type command is used to configure the type of PPPoE
Circuit-ID for a specified port. By default, the PPPoE Circuit-ID type is "ip".
Syntax
pppoe circuit-id type { mac | ip | udf [UDF Value] }
Parameter
mac | ip | udf —— The type of PPPoE Circuit-ID for the port.
mac: The MAC address of the switch will be used to encode the Circuit-ID
option.
ip: The IP address of the switch will be used to encode the Circuit-ID option.
This is the default value.
udf: A user specified string with the maximum length of 32 characters will be
used to encode the Circuit-ID option.
UDF Value —— The value of UDF. The maximum length is 32 characters.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
TL-SL5428E
JetStream L2 Managed Switch CLI Guide
107
Advertisement
Table of Contents
