Chapter 22 System Configuration Commands; System-Time Manual; System-Time Ntp - TP-Link JetStream TL-SL5428E Cli Reference Manual

Chapter 22 System Configuration Commands

System Configuration Commands can be used to configure the system information and system IP
of the switch, and to reboot and reset the switch, upgrade the switch system and commands used
for device diagnose, including loopback test and cable test.

system-time manual

Description
The system-time manual command is used to configure the system time
manually.
Syntax
system-time manual time
Parameter
time
HH:MM: SS.
Command Mode
Global Configuration Mode
Example
Configure the system time as 02/14/2012-12:30:00:
TL-SL5428E(config)#system-time manual 02/14/2012-12:30:00

system-time ntp

Description
The system-time ntp command is used to configure the time zone and the IP
address for the NTP Server. The switch will get UTC automatically if it has
connected to an NTP Server.
Syntax
system-time ntp { timezone } { ntp-server } { backup-ntp-server }
{ fetching-rate }
Parameter
timezone — — Your local time-zone, and it ranges from UTC-12:00 to
UTC+13:00.
The detailed information that each time-zone means are displayed as follow:
TL-SL5428E
—— Set the date and time manually, in the format of MM/DD/YYYY-
JetStream L2 Managed Switch CLI Guide
131