TP-Link JetStream TL-SL5428E Cli Reference Manual page 35

Mode Accessing Path
Use the
Global
command to enter this
Configuration
mode
Mode
EXEC mode.
Use
fastEthernet/gigabitEth
ernet port or interface
Interface
range
Configuration
gigabitEthernet port-list
Mode
command to enter this
mode
Configuration mode.
Use the vlan vlan-list
VLAN
command to enter this
Configuration
mode
Mode
Configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a console port or by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
Global Configuration Mode: In this mode, global commands are provided, such as the

Spanning Tree, Schedule Mode and so on.
Interface Configuration Mode: In this mode, users can configure one or several ports.

Different ports correspond to different commands
a). Interface fastEthernet/gigabitEthernet: Configure parameters for a Fast/Gigabit
Ethernet port, such as Duplex-mode, flow control status.
b). Interface range fastEthernet/gigabitEthernet: Configure parameters for several
Ethernet ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
TL-SL5428E
configure
TL-SL5428E(config)#
from Privileged
the interface
TL-SL5428E(config-if)#
fastEthernet/
TL-SL5428E(config-if-
from Global
TL-SL5428E(config-
from Global
JetStream L2 Managed Switch CLI Guide
Prompt Logout or Access the next mode
Use the exit or the end command or
press Ctrl+Z to return to Privileged
EXEC mode.
Use
gigabitEthernet port or interface range
fastEthernet/gigabitEthernet
command
Configuration mode.
Use the vlan vlan-list to access VLAN
Configuration mode.
Use the end command or press Ctrl+Z to
return to Privileged EXEC mode.
Enter exit or # command to return to
Global Configuration mode.
A port number must be specified in the
range)#
interface command.
Use the end command or press Ctrl+Z to
return to Privileged EXEC mode.
vlan)#
Enter the exit or # command to return to
Global configuration mode.
19
the interface fastEthernet/
to access interface
port-list