Switchport General Allowed Vlan; Switchport Pvid - TP-Link JetStream TL-SL5428E Cli Reference Manual

switchport general allowed vlan

Description
The switchport general allowed vlan command is used to add the desired
General port to IEEE 802.1Q VLAN, or to remove a port from the corresponding
VLAN.
Syntax
switchport general allowed vlan vlan-list { tagged | untagged }
no switchport general allowed vlan vlan-list
Parameter
vlan-list —— VLAN ID list, ranging from 2 to 4094, in the format of 2-3, 5. It is
multi-optional.
tagged | untagged —— egress-rule.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Configure Fast Ethernet port 4 whose link type is "general" to VLAN 2 and its
egress-rule as "tagged":
TL-SL5428E(config)#interface fastEthernet 1/0/4
TL-SL5428E(config-if)#switchport mode general
TL-SL5428E(config-if)#switchport general allowed vlan 2 tagged

switchport pvid

Description
The switchport pvid command is used to configure the PVID for the switch
ports.
Syntax
switchport pvid vlan-id
TL-SL5428E JetStream L2 Managed Switch CLI Guide
30