Logging File Flash Level - TP-Link JetStream TL-SL5428E Cli Reference Manual

Immediate—— The system log file in the buffer will be synchronized to the flash
immediately. This option will reduce the life of the flash and is not
recommended.
Command Mode
Global Configuration Mode
Example
Specify the log file synchronization frequency as 10 hours:
TL-SL5428E(config)# logging file flash frequency periodic10

logging file flash level

Description
The logging file flash level command is used to specify the system log
message severity level. Messages will a severity level equal to or higher than
this value will be stored to the flash. To restore to the default level, please use
no logging file flash level command.
Syntax
logging file flash level level
no logging file flash level
Parameter
level —— Severity level of the log information. There are 8 severity levels
marked with values 0-7. The smaller value has the higher priority. Only the log
with the same or smaller severity level value will be output. By default, it is 2
indicating that the log information marked with 0–2 will be saved in the log
buffer.
Command Mode
Global Configuration Mode
Example
Enable the log file function and set the severity as 7:
TL-SL5428E(config)#logging file flash level 7
TL-SL5428E JetStream L2 Managed Switch CLI Guide
112