Snmp-Server Traps Link-Status; Snmp-Server Traps - TP-Link JetStream TL-SL5428E Cli Reference Manual
24-port 10/100mbps + 4-port gigabit jetstream l2 managed switch
Hide thumbs
Also See for JetStream TL-SL5428E:
- Reference manual (341 pages) ,
- User manual (307 pages) ,
- Cli reference manual (245 pages)
Table of Contents
Advertisement
Example
Enable the dhcp-filter trap for the switch:
TL-SL5428E(config)# snmp-server traps security dhcp-filter
snmp-server traps link-status
Description
The snmp-server traps link-status command is used to enable SNMP link
status trap for the specified port. To disable the sending of SNMP link status trap,
please use no snmp-server traps link-status command.
Syntax
snmp-server traps link-status
no snmp-server traps link-status
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Example
Enable SNMP link status trap for port 3:
TL-SL5428E(config)# interface gigabitEthernet 1/0/3
TL- SG3424P(config-if)# snmp-server traps link-status
snmp-server traps
Description
The snmp-server traps command is used to enable SNMP extended traps. To
disable the sending of SNMP extended traps, please use no snmp-server
traps command.
Syntax
snmp-server traps { bandwidth-control | cpu | flash | ipaddr-change | lldp |
loopback-detection | storm-control | spanning-tree | memory }
no snmp-server traps { bandwidth-control | cpu | flash | ipaddr-change | lldp |
loopback-detection | storm-control | spanning-tree | memory }
TL-SL5428E
JetStream L2 Managed Switch CLI Guide
276
Advertisement
Table of Contents
