Ip Source Binding Index - TP-Link JetStream TL-SL5428E Cli Reference Manual

Command Mode
Global Configuration Mode
Example
Bind an ACL entry with the IP 192.168.0.1, MAC 00:00:00:00:00:01, VLAN ID 2
and the Port number 5 manually. And then enable the entry for the ARP
detection and IP filter function:
TL-SL5428E(config)#ip source binding host1 192.168.0.1 00:00:00:00:00:01
vlan 2 interface fastEthernet 1/0/5 both
Delete the IP-MAC –VID-PORT entry with the index 5:
TL-SL5428E(config)#no ip source binding index 5

ip source binding index

Description
The ip source binding index command is used to modify the existing entry of
ip source binding.
Syntax
ip source binding index idx {hostname hostname | mac mac-addr | vlan
vlan-id| interface { fastEthernet port | gigabitEthernet port} | none |
arp-detection | ip-verify-source | both }
Parameter
idx ——The entry number needed to be modified. You can use the
source binding
the actual number in the binding table which is not displayed in an arranged
order.
hostname ——The modified Host Name, which contains 20 characters at most.
mac-addr —— The modified MAC address of the Host.
vlan-id ——The modified VLAN ID, ranging from 1 to 4094.
port —— The modified number of port connected to the Host.
none | arp-detection | ip-verify-source | both ——The modified protect type for
the entry. "arp-detection" indicates ARP detection; "ip-verify-source" indicates IP
source filter; "none" indicates applying none; "both" indicates applying both.
TL-SL5428E JetStream L2 Managed Switch CLI Guide
command to get the idx. Pay attention that the entry number is
74
show ip