Lldp Snmp-Trap; Lldp Tlv-Select - TP-Link TL-SG5412F Reference Manual

lldp snmp-trap

Description
The lldp snmp-trap command is used to enable the ports' SNMP notification. If
enabled, the port will notify the trap event to network management system. To
disable this function, please use no lldp snmp-trap command.
Syntax
lldp snmp-trap
no lldp snmp-trap
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Enable the ports' SNMP notification for port8:
TP-LINK(config)# interface ethernet 8
TP-LINK(config-if)# lldp snmp-trap

lldp tlv-select

Description
The lldp tlv-select command is used to configure TLVs to be included in
outgoing LLDPDU. To exclude TLVs, please use no lldp tlv-select command.
By default, All TLVs are included in outgoing LLDPDU.
Syntax
lldp tlv-select [port-description] [system-capability] [system-description]
[system-name] [management-address] [port-vlan-id] [protocol-vlan-id]
[vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all]
no lldp tlv-select [port-description] [system-capability] [system-description]
[system-name] [management-address] [port-vlan-id] [protocol-vlan-id]
[vlan-name] [link-aggregation] [mac-phy] [max-frame-size] [power] [all]
Command Mode
Interface Configuration Mode（interface ethernet / interface range ethernet）
Example
Exclude "management-address" and "port-vlan-id" TLVs in LLDPDU outgoing
from port 8:
201