Snmp-Server Traps Security - TP-Link JetStream TL-SL5428E Cli Reference Manual

Example
Enable the linkup trap for the switch:
TL-SL5428E(config)# snmp-server traps snmp linkup

snmp-server traps security

Description
The snmp-server traps security command is used to enable SNMP security
traps which include four types: dhcp-filter, ip-duplicate, ip-mac-binding, and
port-access. To disable the sending of SNMP security traps, please use no
snmp-server traps security command.
Note:
The snmp-server traps security command without any parameter is used to
enable all the four types of traps. And the no snmp-server traps security
command without any parameter is used to disable all the four types of traps.
Syntax
snmp-server traps security [dhcp-filter | ip-duplicate | ip-mac-binding |
port-access ]
no snmp-server traps security [dhcp-filter | ip-duplicate | ip-mac-binding |
port-access ]
Parameter
dhcp-filter —— Enable the dhcp-filter trap. It is sent when the device receives a
DHCP packet from an untrusted port. By default, it is disabled.
ip-duplicate ——Enable the ip-duplicate trap. It is sent when another host uses
the switch's IP address. By default, it is disabled.
ip-mac-binding —— Enable the ip-mac-binding trap. It is sent when it receives a
packet from the host that does not match the entries in IP-MAC binding table. By
default, it is disabled. To view the IP-MAC binding table, please enter the
ip source binding
port-access —— Enable the port-access trap. It is sent when some users try to
log on to the web management page via ports that have no authority. By default,
it is disabled.
Command Mode
Global Configuration Mode
TL-SL5428E JetStream L2 Managed Switch CLI Guide
command.
275
show