Ethernet-Oam Link-Monitor Symbol-Period - TP-Link JetStream TL-SL5428E Cli Reference Manual

Syntax
ethernet-oam mode { passive | active }
no ethernet-oam mode
Parameter
passive —— Specify the OAM mode as passive.
active ——Specify the OAM mode as active.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet)
Example
Configure Ethernet OAM client to operate in passive mode for Fast Ethernet
port 2:
TL-SL5428E(config)# interface fastEthernet 1/0/2
TL-SL5428E(config-if)#ethernet-oam mode passive

ethernet-oam link-monitor symbol-period

Description
The ethernet-oam link-monitor symbol-period command is used to configure
the parameters about one of the link events, error symbol period event. To
return to the default configurations, please use no ethernet-oam link-monitor
symbol-period command.
Syntax
ethernet-oam link-monitor symbol-period { threshold threshold | window
window | notify { disable | enable }}
no ethernet-oam link-monitor symbol-period { threshold | window | notify }
Parameter
threshold —— Configure the error threshold for generating error symbol-period
event. The range is from 1 to 4294967295 and the default value is 1.
window —— Configure the error symbol-period event detection interval. The
range is from 10 to 600, in terms of 100 ms intervals. The default value is 10.
TL-SL5428E JetStream L2 Managed Switch CLI Guide
218