Chapter 23 Ipv6 Address Configuration Commands; Ipv6 Enable; Ipv6 Address Autoconfig - TP-Link JetStream TL-SL5428E Cli Reference Manual

Chapter 23 IPv6 Address Configuration Commands

The IPv6 address configuration commands are provided in the Interface VLAN Mode. Type
enable →configure→interface vlan {vlan-id} to enter the Interface Configuration Mode of the
management VLAN. By default the management VLAN is VLAN1. You can use the command ip
management-vlan {vlan-id} in the Global Configuration Mode to configure the management
VLAN.

ipv6 enable

Description
This command is used to enable the IPv6 function globally. The IPv6 function should be
enabled before the IPv6 address configuration management. By default it is enabled. If
the IPv6 function is disabled, the corresponding IPv6 netstack and IPv6-based modules
will be invalid, for example SSHv6, SSLv6, TFTPv6 etc. To disable the IPv6 function,
please use no ipv6 enable command.
Syntax
ipv6 enable
no ipv6 enable
Command Mode
Interface Configuration Mode（interface vlan）
Example
Enable the IPv6 function when the management VLAN of the switch is VLAN1：
TL-SL5428E(config)# interface vlan 1
TL-SL5428E(config-if)# ipv6 enable

ipv6 address autoconfig

Description
This command is used to enable the automatic configuration of the ipv6 link-local
address. The switch has only one ipv6 link-local address, which can be configured
automatically or manually. The general ipv6 link-local address has the prefix as
fe80::/10. IPv6 routers cannot forward packets that have link-local source or
destination addresses to other links. The autuconfigured ipv6 link-local address is in
EUI-64 format. To verify the uniqueness of the link-local address, the manually
TL-SL5428E JetStream L2 Managed Switch CLI Guide
149