Event Log Messages; Displaying The Configuration File; Cli: Viewing The Configuration File - HP ProCurve Management And Configuration Manual

Message
DNS server address not configured
DNS server not responding
Unknown host < host-name >
Switch-Initiated DNS packets go out through the VLAN having the
■
best route to the DNS server, even if a Management VLAN has been
configured.
The traceroute command output shows only IP addresses.
■
■ The DNS server address must be manually input. It is not be automat­
ically determined via DHCP.
■ Operation with IPv4 DNS servers has been verified and, while no
problems with servers supporting both IPv4 and IPv6 addresses are
expected, testing has not been performed with such servers. (IPv6
AAAA-style queries are not supported.)

Event Log Messages

Meaning
The switch does not have an IP address configured for the DNS
server.
The DNS server failed to respond or is unreachable. An incorrect
server IP address can produce this result.
The host name did not resolve to an IP address. Some reasons for
this occurring include:
• The host name was not found.
• The named domain was not found.
• The domain suffix was expected, but has not been configured. (If
the server's IP address has been configured in the switch but the
domain name has not been configured, then the host's fully
qualified domain name must be used.)

Displaying the Configuration File

The complete switch configuration is contained in a file that you can browse
from either the web browser interface or the CLI. It may be useful in some
troubleshooting scenarios to view the switch configuration.

CLI: Viewing the Configuration File

Using the CLI, you can display either the running configuration or the startup
configuration. (For more on these topics, refer to Chapter 6, "Switch Memory
and Configuration".)
Troubleshooting
Diagnostic Tools
C-57