Status And Counters Data - HP ProCurve Management And Configuration Manual

N o t e
Status or Counters Type
Menu Access to Status and Menu
Counters
General System
Information
Management Address
Information
Module Information
Port Status
Port and Trunk Statistics
and Flow Control Status
VLAN Address Table
Port Address Table
STP Information
IGMP Status
VLAN Information
Port Status Overview and
Port Counters

Status and Counters Data

This section describes the status and counters screens available through the
switch console interface and/or the web browser interface.
You can access all console screens from the web browser interface via Telnet
to the console. Telnet access to the switch is available in the Device View
window under the Configuration tab.
Interface
Access menu interface for status and counter data.
Menu, CLI Lists switch-level operating information.
Menu, CLI Lists the MAC address, IP address, and IPX network number for
each VLAN or, if no VLANs are configured, for the switch.
Menu, CLI Lists the module type and description for each slot in which a
module is installed.
Menu, CLI, Displays the operational status of each port.
Web
Menu, CLI, Summarizes port activity and lists per-port flow control status.
Web
Menu, CLI Lists the MAC addresses of nodes the switch has detected on
specific VLANs, with the corresponding switch port.
Menu, CLI Lists the MAC addresses that the switch has learned from the
selected port.
Menu, CLI Lists Spanning Tree Protocol data for the switch and for individual
ports. If VLANs are configured, reports on a per-VLAN basis.
Menu, CLI Lists IGMP groups, reports, queries, and port on which querier is
located.
Menu, CLI For each VLAN configured in the switch, lists 802.1Q VLAN ID and
up/down status.
Web Shows port utilization and counters, and the Alert Log.
Monitoring and Analyzing Switch Operation
Status and Counters Data
Purpose Page
B-6
B-7
B-8
B-9
B-11
B-12
B-15
B-15
B-19
B-20
B-21
B-23
B-5