Warning" Poe Event-Log Messages - HP ProCurve Management And Configuration Manual

Message
W < > <
MM / DD / YY HH
Slot < slot-id > POE usage has exceeded
threshold of < 1 - 99 > %
Port < port-id > PD Denied power due to
insufficient power allocation.
Port < port-id > PD Invalid Signature
indication
Port < port-id > PD MPS Absent indication
Port < port-id > PD Other Fault indication
Port < port-id > PD Over Current
indication
50v Power Supply is faulted.
Failures:x
50v Power Supply is OK. Failures:x

"Warning" PoE Event-Log Messages

> chassis
: MM : SS
Power Over Ethernet (PoE) Operation
Meaning
Message header, with severity, date, system time, and
system module type. For more information on Event Log
operation, including severity indicators, refer to "Using the
Event Log To Identify Problem Sources" on page C-26".
Indicates that POE usage in the indicated slot has exceeded
the configured threshold for the module, as specified by the
last execution of the power threshold or power slot < slot-
id > threshold command. (Note that the switch also
generates an SNMP trap for this event.)
There is insufficient power available to power the PD on the
indicated port and the port does not have sufficient PoE
priority to take power from another active PoE port.
The switch has detected a non-802.3af-compliant device on
the indicated port. This message appears for all non-802.3af
devices connected to the port, such as other switches, PC-
NICs, etc.
The switch no longer detects a device on < port-id >. The
device may have been disconnected, powered down, or
stopped functioning.
There is a problem with the PD connected to the port.
The PD connected to < port-id > has requested more than
15.4 watts of power. This may indicate a short-circuit or
other problem in the PD.
Internal power supply has faulted.
Internal power supply is now OK.
PoE Operating Notes
11-29