Example Of Configuring And Displaying A Banner - HP ProCurve Management And Configuration Manual

Advantages of Using ProCurve Manager or ProCurve Manager Plus
Use show banner motd to display the current banner status.
Syntax: banner motd < delimiter >
no banner motd
This command defines the single character used to termi­
nate the banner text and enables banner text input. You
can use any character except a blank space as a delimiter.
The no form of the command disables the login banner
feature.
< banner-text-string >
The switch allows up to 320 banner characters, including
blank spaces and CR-LF ([Enter]). (The tilde "
delimiter defined by banner motd <delimiter> are not
allowed as part of the banner text.) While entering banner
text, you can backspace to edit the current line (that is, a
line that has not been terminated by a CR-LF.) However,
terminating a line in a banner by entering a CR-LF
prevents any further editing of that line. To edit a line in
a banner entry after terminating the line with a CR-LF
requires entering the delimiter described above and then
re-configuring new banner text.
The banner text string must terminate with the character
defined by banner motd < delimiter >.
Note: In redundant management, the banner is not seen
on the standby module, only the active module.

Example of Configuring and Displaying a Banner

Suppose a system operator wanted to configure the following banner message
on her company's switches:
This is a private system maintained by the
Allied Widget Corporation.
Unauthorized use of this system can result in
civil and criminal penalties!
In this case, the operator will use the [Enter] key to create line breaks, blank
spaces for line centering, and the % symbol to terminate the banner message.
Selecting a Management Interface
~
" and the
2-11