Enabling Or Disabling Redundant Management - HP ProCurve Management And Configuration Manual

Redundancy (Switch 8212zl)
Using Redundant Management
ProCurve(config)# show redundancy
Settings
--------
Mgmt Redundancy : enabled
Statistics
----------
Failovers
Last Failover :
Slot Module Description
---- ---------------------------------------- -------- ---------- ----------
MM1 ProCurve J9092A Management Module 8200zl Active
MM2 ProCurve J9092A Management Module 8200zl Standby
FM1 ProCurve J9093A Fabric Module 8200zl
FM2 ProCurve J9093A Fabric Module 8200zl
Figure 15-1. Example of show redundancy Command for Management and Fabric Modules
15-6
: 0

Enabling or Disabling Redundant Management

You can enable or disable redundant management using this command in
global configuration context:
Syntax: [no] redundancy management-module
Allows enabling or disabling of redundant management. The
current active module continues to be the active module on
boot unless you use the redundancy active-management
command to make the other module the active module.
When you enable redundancy you are prompted with "All
configuration files and software images on the off-line
management module will be overwritten with the data from
the current active management module. Do you want to
continue [y/n]?"
The no version of the command disables redundant
management. You are prompted with this message: "The
other management module may reboot and it will no longer
be used for system redundancy except in the case of a
hardware failure of the active management module. Do you
want to continue [y/n]?". Selecting "y" disables redundant
management.
The redundancy management-module command in Figure 15-2 shows redundant
management being enabled. The show redundancy command displays "Mgmt
Redundancy" as enabled. Management Module 1 is the standby management
module and Management Module 2 is the active management module.
Status SW Version Boot Image
K.12.30
K.12.30
Enabled
Enabled
Primary
Primary