Show Version - HP ProCurve Management And Configuration Manual

ProCurve(config)# show version
Management Module 1:
Management Module 2: Active
Image stamp: /sw/code/build/btm(t2g)
Mar
K.12.XX
351
Boot Image: Primary
Figure 15-17. Example of show version Command when Redundancy is Disabled

Show Version

The show version command displays system software image information for
both management modules as well as which module is the active management
module and which is the standby management module. The Boot Image field
displays which flash image last booted from, even if the boot set-default
command has been set to change the flash booted from on the next boot. The
output of the show version command when redundancy is enabled is shown in
Figure 15-16.
ProCurve(config)# show version
Management Module 1: Standby
Image stamp: /sw/code/build/btm(t2g)
Mar
K.12.XX
351
Boot Image: Primary
Management Module 2: Active
Image stamp: /sw/code/build/btm(t2g)
Mar
K.12.XX
351
Boot Image: Primary
Figure 15-16. Example of Show Version Command when Redundancy is Enabled
When redundancy is disabled, the output of the show version command
changes, as shown in Figure 15-17.
R edundancy and Synchronization has been disabled:
enable with the 'redundancy' command.
5 2007 13:20:59
Displaying Management Information
5 2007 13:20:59
5 2007 13:20:59
Redundancy (Switch 8212zl)
Both management
modules were booted
from primary flash.
15-25