Cli: Viewing Port Status And Configuring Port Parameters; Viewing Port Status And Configuration - HP ProCurve Management And Configuration Manual

CLI: Viewing Port Status and Configuring Port
Parameters
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Port Status and Configuration Commands
show interfaces brief
show interfaces config
show interfaces port-utilization
show tech transceivers
interface
disable/enable
speed-duplex
flow-control
broadcast-limit
auto-mdix

Viewing Port Status and Configuration

Use the following commands to display port status and configuration data.
Syntax: show interfaces [ brief | config | < port-list >]
brief: Lists the current operating status for all ports on the
switch.
config: Lists a subset of configuration data for all ports on the
switch; that is, for each port, the display shows whether the port
is enabled, the operating mode, and whether it is configured
for flow control.
< port-list >: Shows a summary of network traffic handled by the
specified ports.
An example of the show interfaces brief command is shown below.
Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
page 10-8
page 10-8
page 10-9
page 10-9
page 10-11
page 10-11
page 10-11
page 10-12
page 10-14
page 10-15
10-7