HP ProCurve Management And Configuration Manual page 567

ProCurve# show monitor
Network Monitoring
S tatus
Sessions
-------- -----------
1 active
2 active
3 not defined
4 inactive
Remote Mirroring - Remote Endpoints
Type UDP Source Addr
---- ---------------
IPv4 10.10.30.1
Figure B-20. Example of a Currently Configured Mirroring Summary on a Source Switch
Syntax: show monitor
UDP Dest Addr: The IP address configured as the destination
VLAN or subnet on which the exit port exists. (For a given
mirroring session, this value should be the same on the source
and destination switches.)
Dest Port: For a given mirroring session, identifies the exit port
on the destination switch.
For example, the following summary shows three mirroring sources (one local
and two remote) and one remote mirroring destination configured on the
switch.
Type
-----
port
IPv4
IPv4
UDP port
--------
7950
Monitoring and Analyzing Switch Operation
—Continued from Previous Page—
Sources ACL
------- ---
1 yes
2 no
0 no
UDP Dest Addr
---------------
10.10.20.1
Traffic Mirroring
Local and Remote Mirroring
Sources:
• Session 1 is performing local
mirroring from an ACL source.
• Session 2 is performing remote
mirroring using non-ACL sources.
• Session 3 is not configured.
• Session 4 is configured for remote
mirroring from a non-ACL source,
but is currently not mirroring any
traffic.
Remote Mirroring Destination:
The switch is configured as a
remote mirroring destination
(endpoint) for a source at
10.10.30.1, and is using port B10 as
the exit port.
Dest Port
-------- -
B10
B-57