HP ProCurve Management And Configuration Manual page 444

Redundancy (Switch 8212zl)
Downloading a New Software Version
ProCurve(config)# show version
Management Module 1: Active
Image stamp: /sw/code/build/btm(t2g)
Mar 15 2007 12:28:32
K.12.29
64
Boot Image: Primary
Management Module 2: Standby
Image stamp: /sw/code/build/btm(t2g)
Mar 21 2007 14:24:38
K.12.30
789
Boot Image: Secondary
ProCurve(config)# show redundancy
Settings
------- -
Mgmt Redundancy : Enabled
Statistics
--------- -
Failovers
Last Failover :
Slot Module Description
---- ---------------------------------------- -------- ---------- ----------
MM1 ProCurve J9092A Management Module 8200zl Active
MM2 ProCurve J9092A Management Module 8200zl Standby
FM1 ProCurve J9093A Fabric Module 8200zl
FM2 ProCurve J9093A Fabric Module 8200zl
Warning: Standby module is running a different software version. Configuration
changes on active management module may not take effect on a failover. See "show
version".
Figure 15-11. Example of a Software Version Mismatch Between the Active and Standby Modules
15-20
: 0
Mismatch exists
Status SW Version Boot Image
K.12.30
K.12.30
Enabled
Enabled
Primary
Primary