HP ProCurve Management And Configuration Manual page 366

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
14-22
Syntax: snmp-server host <ip-address> <community name> [none | debug | all |
not-info | critical]
Using community name and destination IP address,
this command designates a destination network-
management station for receiving SNMP event log
messages from the switch. If you do not specify the
event level, then the switch does not send event log
messages as traps. You can specify up to 10 trap
receivers (network management stations).
Note: In all cases, the switch sends any threshold
trap(s) to the network management station(s) that
explicitly set the threshold(s).
[<none | all | non-info | critical | debug>]
Options for sending switch Event Log messages to a
trap receiver. Refer toTable 14-1, "Options for Sending
Event Log Messages as Traps," on page 14-22. The levels
specified with these options apply only to Event Log
messages, and not to threshold traps.
Table 14-1. Options for Sending Event Log Messages as Traps
Event Level Description
None (default) Send no log messages.
All Send all log messages.
Not INFO Send the log messages that are not information-only.
Critical Send critical-level log messages.
Debug Reserved for HP-internal use.
For example, to configure a trap receiver in a community named "red-team"
with an IP address of 10.28.227.130 to receive only "critical" log messages:
ProCurve(config)# snmp-server trap-receiver red-team
10.28.227.130 critical