Show Flash; Show Version - HP ProCurve Management And Configuration Manual

Standby Console> show redundancy
Settings
--------
Mgmt Redundancy : Enabled
Statistics
----------
Failovers
Last Failover : Mon Sep 26 09:50:40 2005
Slot Module Description
---- ---------------------------------------- -------- ---------- ----------
MM1 ProCurve J9092A Management Module 8200zl Active
MM2 ProCurve J9092A Management Module 8200zl Standby
FM1 ProCurve J9093A Fabric Module 8200zl
FM2 ProCurve J9093A Fabric Module 8200zl
Figure 15-19. Example of Show Redundancy Command for Standby Module
: 1

Show Flash

You can display the flash information on the standby module, as shown in
Figure 15-20. The Default Boot field displays which flash image will be used
for the next boot.
Standby Console> show flash
Image Size(Bytes)
----- ----------
Primary Image : 7493854
Secondary Image : 7463821
Boot Rom Version: K.12.10
Default Boot : Primary
Figure 15-20. Example of Show Flash Command for Standby Module

Show Version

You can display the version information on the standby module, as shown in
Figure 15-21. The Boot Image field displays which flash image was last booted
from, even if the boot set-default command has been set to change the flash
Redundancy (Switch 8212zl)
Displaying Management Information
The active management module was last booted from
secondary flash. The standby management module
was last booted from primary flash.
Status SW Version Boot Image
K.12.30
K.12.30
Enabled
Enabled
Date Version
-------- -------
03/21/07 K.12.30
03/05/07 K.12.30
Will boot from primary flash
on the next boot.
Secondary
Primary
15-27