Configuring Jumbo Frame Operation; Overview - HP ProCurve Management And Configuration Manual

Port Traffic Controls
Jumbo Frames
13-28

Configuring Jumbo Frame Operation

Command
show vlans
show vlans ports < port-list > 13-30
show vlans < vid >
jumbo

Overview

1. Determine the VLAN membership of the ports or trunks through which
you want the switch to accept inbound jumbo traffic. For operation with
GVRP enabled, refer to the GVRP topic under "Operating Rules", above.
2. Ensure that the ports through which you want the switch to receive jumbo
frames are operating at least at gigabit speed. (Check the Mode field in the
output for the show interfaces brief < port-list > command.)
3. Use the jumbo command to enable jumbo frames on one or more VLANs
statically configured in the switch. (All ports belonging to a jumbo-
enabled VLAN can receive jumbo frames.
4. Execute write memory to save your configuration changes to the startup­
config file.
Page
13-29
13-31
13-31