HP ProCurve Management And Configuration Manual page 354

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
Add NetworkAdmin to
operator noauth group
Figure 14-3. Example of Assigning Users to Groups
14-10
Assigning Users to Groups. Then you must set the group access level for
the user by assigning the user to a group. This is done with the snmpv3 group
command. For more details on the MIBs access for a given group refer to
"Group Access Levels" on page 14-11.
SNMPv3 Group Commands
Syntax: [no] snmpv3 group
This command assigns or removes a user to a security group
for access rights to the switch. To delete an entry, all of the
following three parameters must be included in the
command.
group <group_name>
This parameter identifies the group that has the privileges
that will be assigned to the user. For more details refer to
"Group Access Levels" on page 14-11.
user <user_name>
This parameter identifies the user to be added to the access
group. This must match the user name added with the snmpv3
user command.
sec-model <ver1 | ver2c | ver3>
This defines which security model to use for the added user.
A SNMPv3 access Group should only use the ver3 security
model.
Add NetworkMgr to managerpriv group
Pre-assigned groups for
access by Version 2c and
version 1 management
applications