Cli: Viewing And Configuring Timep; Viewing The Current Timep Configuration - HP ProCurve Management And Configuration Manual

Time Protocols
TimeP: Viewing, Selecting, and Configuring
Figure 9-13. Example of TimeP Configuration When TimeP Is the Selected Time
9-18

CLI: Viewing and Configuring TimeP

CLI Commands Described in this Section
Command
show timep
[no] timesync
ip timep
dhcp
manual
server <ip-addr>
interval
no ip timep
This section describes how to use the CLI to view, enable, and configure TimeP
parameters.

Viewing the Current TimeP Configuration

Using different show commands, you can display either the full TimeP config­
uration or a combined listing of all TimeP, SNTP, and VLAN IP addresses
configured on the switch.
Syntax: show timep
This command lists both the time synchronization method
(TimeP, SNTP, or None) and the TimeP configuration, even if
SNTP is not the selected time protocol. (If the TimeP Mode is
set to Disabled or DHCP, then the Server field does not appear.)
For example, if you configure the switch with TimeP as the time synchroniza­
tion method, then enable TimeP in DHCP mode with the default poll interval,
lists the following:
show timep
Synchronization Method
Page
9-18
9-20 ff., 9-23
9-20
9-21
9-21
9-22
9-23