Step 6: Connect The Power - Promise Technology VTRAK J300s Quick Start Manual

Step 6: Connect the Power

Plug the power cords and switch on both power supplies on. When the power is
switched on, the LEDs on the front of the VTrak will light up.
Figure 12.VTrak J300s front panel LED display
When boot-up is finished and the VTrak is functioning normally:
• The heartbeat LED blinks green once every 3 seconds if one I/O module is
installed, or twice every 3 seconds if two I/O modules are installed.
• Power and FRU LEDs display green continuously.
• I/O module LEDs flash green if there is activity on that connection.
There are two LEDs on each Drive Carrier. They report the presence of power
and a disk drive, and the current condition of the drive.
Figure 13.VTrak J300s disk carrier LEDs
After a few moments the Power/Activity should display Green.
If there is no disk drive in the carrier, the Disk Status LED and the Power/Activity
LED will remain dark.
Power
FRU Status
Not Used
I/O module-1 activity
I/O module-2 activity
Heartbeat
11
Step 6: Connect the Power
Disk Status
Power/Activity