Jamming Detection; Batt Load Test - Abus SECVEST 868 Installation Instructions Manual

10.7.13. Jamming Detection

to select Jamming Detection.
Use the control buttons
Confirm your selection by pressing the control button
word Select. To cancel input, press the control button
word Back.
If you confirm Jamming Detection with the Select button, you see the
following graphic display:
Use the control buttons
display a warning in the case of jamming detection. If this function is
enabled, a warning is issued on the display if jamming is detected. To
select a function, press the control button
To cancel input, press the control button
to select whether the alarm system is to
under the word Select.
under the word Back.

10.7.14. Batt Load Test

Use the control buttons
under the
selection by pressing the control button
under the
cancel input, press the control button
If you confirm Batt Load Test with the Select button, you see the
following graphic display:
Use the control buttons
test the battery capacity at every disarming or every 23 hours. If the
function is disabled, the system tests other less important functions
every hour. To select a function, press the control button
the word Select. To cancel input, press the control button
the word Back.
To select a function, press the control button
Select. To cancel input, press the control button
Back.
(If the radio alarm panel is communicating or playing/recording
speech then the radio alarm panel will delay the test until those
activities are finished.)
If mains power is absent then the radio alarm panel carries out the test
as soon as mains power is restored.
50
to select Batt Load Test. Confirm your
under the word Select. To
under the word Back.
to select whether the alarm system is to
under the word
under the word
under
under