Installing Right-Side Components - Arctic Cat 350 2011 Service Manual

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
NOTE: The oil pump is a non-serviceable compo-
nent and must be replaced as a complete assem-
bly.
DRIVEN PULLEY ASSEMBLY
NOTE: The driven pulley assembly is a non-ser-
viceable component and must be replaced as a
complete assembly.
Installing Right-Side
Components
A. Oil Pump
1. Place two alignment pins and the oil pump into
position on the crankcase and secure with the Phil-
lips-head screws coated with blue Loctite #243.
Tighten to 8 ft-lb.
2. Place the thrust washer and drive pin into position
on the oil pump shaft, install the oil pump driven
gear making sure the recessed side of the gear is
directed inward, and secure with a new snap ring.
NOTE: Always use a new snap ring when install-
ing the oil pump driven gear.
3-32
MD1060
MD1020
www.mymowerparts.com
Manual
Table of Contents
3. Install the cam chain.
NOTE: Keep tension on the cam chain to avoid
damaging the crankcase boss.
4. Place the pin into position, install the oil pump
drive gear, and tighten the cap screw (coated with
red Loctite #271) to 63 ft-lb.
5. Install the clutch shoe assembly on the crankshaft;
then install the flange nut (left-hand thread)
(coated with red Loctite #271). Tighten to 147
ft-lb.
NOTE: The flat side of the flange nut should be
directed towards the clutch shoe.
CAUTION
Care must be taken when installing the flange nut; it
has "left-hand" threads.
Section
Table of Contents
MD1019
MD1017
MD1018