For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
8. Using the Magneto Rotor Remover Set, break the
rotor/flywheel loose from the crankshaft; then
remove the puller and crankshaft protector and
remove the rotor/flywheel.
9. Remove the flywheel key from the crankshaft;
then remove the starter clutch gear.
10. Remove starter idler gears and their respective
shafts; then remove the starter motor. Account for
an O-ring on the starter drive housing.
G. Shift Shaft
H. Drive Gear
NOTE: Steps 1-10 in the preceding sub-sections
must precede this procedure.
11. Remove the shift shaft noting a washer on each
end; then remove the cap screw securing the gear
shift cam plate and remove the plate from the
shaft.
3-64
FI550
FI551A
FI555
www.mymowerparts.com
Manual
Table of Contents
12. Remove the shift detent cam arm and spring.
13. Remove the snap ring securing the output drive
gear to the output shaft and remove the gear noting
that the hub flange is directed toward the crank-
case.
Section
Table of Contents
FI559
FI560
FI564
FI566