Rear Body Panel/Rack - Arctic Cat 350 2011 Service Manual

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
2. Slide the muffler rearward to clear the mounting
lugs and remove the muffler. Account for a grafoil
seal.
INSPECTING MUFFLER
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect muffler externally for cracks, holes, and
dents.
2. Inspect the muffler internally by shaking the muf-
fler back and forth and listening for rattles or loose
debris inside the muffler.
NOTE: For additional details on cleaning the muf-
fler/spark arrester, see Periodic Maintenance.
INSTALLING MUFFLER
1. Using a new grafoil seal, place the muffler into
position engaging the mounting lugs into the
grommets; then slide the muffler forward.
2. Install the two exhaust springs.

Rear Body Panel/Rack

REMOVING
1. Remove the rear rack; then remove two cap screws
securing the rear body panel/fender to the side
frame and the cap screws securing the rear fenders
to the footwells.
KC317A
www.mymowerparts.com
Manual
Table of Contents
2. Disconnect the battery (negative cable first) and
remove from the battery compartment; then dis-
connect the starter relay wires and route the wiring
out of the compartment.
3. Remove the auxiliary brake reservoir from the
body but do not disconnect the hose; then route
and secure the hose and reservoir out of the way
making sure not to spill brake fluid.
4. Using a small screwdriver, remove the light con-
nectors from the frame; then disconnect both con-
nectors and remove the rear body panel/fender.
Section
Table of Contents
KC316
KC322A
8
KC306
8-9