Table Of Contents - Arctic Cat 350 2011 Service Manual

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
Controls/Indicators
Hand Brake
Lever/Master Cylinder
Assembly
NOTE: The master cylinder is a non-serviceable
component; it must be replaced as an assembly.
REMOVING
1. Slide a piece of flexible tubing over one of the
wheel bleeder valves and direct the other end into
a container. Remove the reservoir cover; then open
the bleeder valve. Allow the brake fluid to drain
completely.
NOTE: Compressing the brake lever several
times will quicken the draining process.
2. Place an absorbent towel around the connection to
absorb brake fluid. Remove the banjo-fitting bolt
from the master cylinder. Account for two crush
washers and a banjo-fitting bolt.
CAUTION
Brake fluid is highly corrosive. Do not spill brake fluid
on any surface of the ATV.
3. Remove the clamp screws securing the brake
housing to the handlebar, then remove the assem-
bly from the handlebar.
INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Inspect the pin securing the brake lever for wear.
2. Inspect the brake lever for elongation of the pivot
hole.
9-2
AF637D
www.mymowerparts.com
Manual

Table of Contents

3. Inspect the reservoir for cracks and leakage.
4. Inspect the banjo-fitting and bolt for cracks and
deterioration and the condition of the fittings
(threaded and compression).
INSTALLING
1. Position the brake housing on the handlebar.
Secure with clamp screws; then tighten securely.
2. Using two new crush washers, connect the
banjo-fitting to the master cylinder; then secure
with the banjo-fitting bolt. Tighten to 20 ft-lb.
3. Bleed the brake system (see Periodic Mainte-
nance).
Throttle Control
REMOVING
1. Remove the two machine screws securing the
throttle control to the handlebar.
2. Slide the grommet out of the lower half of the
throttle control; then remove the cable from the
actuator arm.
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control
lever.
Section
Table of Contents
AF676D
AF677D