Arctic Cat 350 2011 Service Manual page 93

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
7. Install the starter clutch gear onto the crankshaft;
then install the rotor/flywheel key in the crank-
shaft.
8. Install the rotor/flywheel and secure with the
flange nut. Tighten to 107 ft-lb.
C. Magneto Cover
D. Water Pump
NOTE: Steps 1-8 in the preceding sub-section
must precede this procedure.
9. Install two alignment pins and place the magneto
cover gasket into position. Install the magneto
cover. Noting the different-lengthed 6 mm cap
screws and the location of the two internal cap
screws, tighten cap screws in a crisscross pattern
to 8 ft-lb.
10. Install the water pump drive gear and secure with
the nut. Tighten to 28 ft-lb.
3-68
FI555A
FI551A
FI596A
www.mymowerparts.com
Manual
Table of Contents
11. Install two alignment pins and a gasket on the
magneto cover; then install the water pump hous-
ing assembly. Tighten the cap screws to 8 ft-lb.
12. Install the water pump cover with a new O-ring
and secure with the four cap screws. Tighten to 8
ft-lb.
Section
Table of Contents
FI547
FI541A
FI539
FI538