Arctic Cat 350 2011 Service Manual page 36

For Discount Arctic Cat Parts Call 606-678-9623 or 606-561-4983
C. Cylinder
D. Piston
NOTE: Steps 1-11 in the preceding sub-section
must precede this procedure.
12. Remove the two nuts securing the right side of the
cylinder to the right-side crankcase half.
13. Lift the cylinder off the crankcase taking care not
to allow the piston to drop against the crankcase.
Account for the gasket and two alignment pins.
 AT THIS POINT
To service cylinder, see Servicing Top-Side Compo-
nents sub-section.
CAUTION
When removing the cylinder, be sure to support the
piston to prevent damage to the crankcase and piston.
14. Using an awl, remove one piston-pin circlip. Take
care not to drop it into the crankcase.
KC337A
MD1214
www.mymowerparts.com
Manual
Table of Contents
15. Using Piston Pin Puller, remove the piston pin.
Account for the opposite-side circlip. Remove the
piston.
NOTE: It is advisable to remove the opposite-side
circlip prior to using the puller.
NOTE: Support the connecting rod with rubber
bands to avoid damaging the rod or install a con-
necting rod holder.
CAUTION
Do not allow the connecting rod to go down inside the
crankcase. If the rod is down inside the crankcase and
the crankshaft is rotated, severe damage will result.
NOTE: If the existing rings will not be replaced
with new rings, note the location of each ring for
proper installation. When replacing with new rings,
replace as a complete set only. If the piston rings
must be removed, remove them in this sequence.
Section
Table of Contents
MD1213
3
MD1219
3-11